We met up last night to have a look at a .NET Gadgeteer module, picking a nice easy module to look at to begin with for: http://www.meetup.com/GadgeteerSouthCoast/. Despite being called the GHI PIR Sensor it is found in the toolbox as a “Motion Sensor”
Here is the view from the top of the module: Read more... (1060 words, 7 images, estimated 4:14 mins reading time)
When you drag a module from the toolbox onto the designer it references the correct DLL’s and adds import statements to the program.cs.
Fig 1: Adding a compass module to the designer. Read more... (3144 words, 22 images, estimated 12:35 mins reading time)
There is a case, where you can get a blue screen of death (BSOD) where your computer just dies/reboots, usually during a NetMF or .NET Gadgeteer deploy and especially if you hit the reset button (on the device) or attempt to pull out the USB cable. Read more... (381 words, 4 images, estimated 1:31 mins reading time)
I swapped the ColourSense (http://gadgeteering.net/module/ghi-colorsense) module for a triple slider (http://gadgeteering.net/module/soldermonkey-triple-slider-module).
Permanent link to this post
(13 words, estimated 3 secs reading time)
[UPDATE] RGB Slider – LED Strip with RGB slider
As requested here is an example of my colour sensor in continuous mode setting the colours of the LED strip. The code below uses the tweaks shown in these two posts:
2) http://stevenjohnston.co.uk/2013/04/11/individually-addressable-multicolour-leds-on-net-gadgeteer/ Read more... (1325 words, estimated 5:18 mins reading time)
Last post I was looking at the individually addressable LEDs and used the ‘ColorSense’ module to detect colours. (But did not get very good results)
This post addresses the issues with the colour sensor. Read more... (4733 words, estimated 18:56 mins reading time)
[UPDATE]: Sarah and Jan emailed me to mention that the 10A@5v power supply is a bit of an overkill. I agree but this is the recommendation from GHI. When I tested my strip on full power it was under 3A@5v . Jan claims his is around 2.6A@5v . This does not account for peak current draw, so you may hit issues, but perhaps the full 10A is a bit much. Read more... (1611 words, 8 images, estimated 6:27 mins reading time)
[UPDATE: C# and VB solutions are at the end, the first part is ONLY an explanation. You do not need to follow the steps, just look at the code at the very end if you are after a fix. ] Read more... (1658 words, 4 images, estimated 6:38 mins reading time)
I was asked to show the source behind the example shown in the .NET Gadgeteer LED Matrix blog post.
(as is, no warranty, and I am sure there are bugs etc blah blah) Read more... (1952 words, estimated 7:48 mins reading time)
An example can go a long way, so rather than a 2 hour presentation with nothing but slides, I decided that the NxtGenUG Christmas special should include an end-to-end .NET Gadgeteer example. The example below includes the steps to build your own data logger to log both temperature and humidity. The coding examples were purposely kept short and do not include all the error checking that should be included, the aim was to show a wide variety of .NET Gadgeteer capabilities resulting in a final working prototype – within the 2 hour limit (including all coding and hardware building)! Read more... (4708 words, 15 images, estimated 18:50 mins reading time)